Woman sweeping tile floor

Deep cleaning your floors will spruce up your whole home — but doing it properly takes a little patience and know-how. Luckily, we’ve drummed up several professionals to offer you some expert tips on deep cleaning your tile floors.

Floor duty

Step 1: Start with the basics

Stacy McCall, president and CEO of ServiceMaster by Stratos in Memphis, says, “Sweeping works fine for most floors, but vacuuming is a better choice, even for tile. Most vacuums have a hard floor surface setting. If not, raise height to maximum setting to avoid scratching [the] floor. This will make mopping easier and prevent dirt that sweeping left behind from being spread around.”

Step 2: Know your surface

David Schliefer of Grout Works in New Jersey says, “In order to clean a tile floor you must first be aware of the type of tile you have. Any natural stone, such as marble and travertine, is sensitive to many cleaning products.” Only use products intended for the type of tile you have.

More tips for cleaning tile floors >>

McCall adds, “Ceramic tiles are made for mopping. A general-purpose cleaner is fine for daily maintenance. Just make sure that you use the grout and tile cleaners recommended by the manufacturer. Not all tiles are the same, and some tile cleaners will mar or dull tiles.”

Mopping 101 >>

For porcelain tile, Cody Smith of Pacific Coast Floors in Victoria, BC, suggests using an alkaline-based cleaner. He says, “It is important that it is alkaline based, as this will break down the grime in the tiles and grout. Using hot water, dilute the cleaner according to its label and use it to mop your floor. Let it soak for a good half an hour, but don’t let it dry. Reapply the cleaning solution liberally when needed.”

Step 3: Determine the dirt

Schliefer says, “Assuming your tile is porcelain or ceramic, which is generally the case, the next step is to figure out what kind of dirt you are trying to clean.”

If the dirt is in the bathroom and shower, then soap scum is probably to blame — in which case he advises, “You will need a good soap-scum remover and a brush that is good for removing soap scum.”

However, if your kitchen tiles are dirty, grease and grime are likely the culprits. He suggests using a de-greasing product or cleaners that say they “cut grease.”

Schliefer says using a clean cotton mop should work fine for most smooth-tiled floors, while rough-textured tiles may require a scrub brush to get them clean.

McCall says that an electric scrubber may be needed if you are working with caked-on messes or stains.

How to tell if your floors are really clean >>

Step 4: Prevention

Finally, McCall adds that prevention is the best medicine for dirty floors. She says, “Don’t forget — the best way to keep your tile floor clean is to prevent it from getting dirty in the first place. Mats, both outside and just inside each door, can go a long way toward preventing dirt from tracking in — just make sure you clean the mats regularly. Making a habit of taking your shoes off at the door can help too.”

More cleaning tips

6 Extreme cleaning tasks that take 10 minutes or less
Can you really deep clean without chemicals?
10-minute home cleaning tips

Tags:

Comments

Comments on "How to deep clean your tile floors"

Sherry January 04, 2014 | 10:03 AM

I have very light-coloured matte porcelain floors that have a faintly textured surface. The surface of the floors, if magnified, would be similar to the surface of an of an orange peel, so dirt and such gets trapped and cannot be cleaned with regular, daily mopping. To say that this floor is a pain in the butt to clean is a huge understatement. I tried lots of other products, but nothing was really good at deep cleaning, until I used a Zep product (orange-coloured liquid) called "Zep Heavy Duty Citrus Degreaser". Not that the floor is greasy, but this product deep cleans and actually lifts the dirt from all those tiny pits in the tile - I use it full strength. You can usually purchase the product in a spray bottle or gallon jug at Home Depot. It is the only way I deep clean this floor now!!! :)

carol January 03, 2014 | 6:29 AM

Cathy, do you have a formula? I assume you are using hot water and the cascade? Or is a paste? Can you share how you are using it?

Cathy Ohler August 09, 2013 | 10:18 AM

I clean my porcelain floors throughout the house with "Cascade complete w/the germ fighting power Dawn and Lemon burst Scent". I have tried all kinds of tile floor cleaners to no avail. Floors were still visibly dirty especially the grout. Cascade Complete worked like a charm and my floors are still "just mopped" clean. I used the same product through out the house, even the bathroom floors, and cannot wait to do the walls. Most wonderful product ever. And by the way I also use it for my china and silver! Great Product!!!

+ Add Comment


(required - not published)